Child pages
  • Search for Inverted Repeats
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Version 1 Current »

For each input sequence the workflow performs a search of inverted repeats.

Then it saves the repeats found on the direct strand to the "direct_strand_repeat_units.fa" file and the complement ones to the "compl_strand_repeat_units.fa" file.

How to Use This Sample

If you haven't used the workflow samples in UGENE before, look at the "How to Use Sample Workflows" section of the documentation.

Workflow Sample Location

The workflow sample "Search for Inverted Repeats" can be found in the "Scwnarios" section of the Workflow Designer samples.

Workflow Image

The opened workflow looks as follows:



Workflow Wizard

The wizard has 3 pages.

  1. Input sequence(s): On this page you must input sequence(s).  



  2. Search for inverted repeats parameters: On this page you can modify inverted repeats parameters.  


    The following parameters are available:

    Annotate asName of the result annotations marking found repeats.
    Min lengthMinimum length of repeats.
    IdentityRepeats identity.
    Min distanceMinimum distance between repeats.
    Max distanceMaximum distance between repeats.

    Filter algorithm

    Filter repeats algorithm.

    Algorithm

    Control over variations of algorithm.

    Parallel threadsNumber of parallel threads used for the task.
  3. Output Sequences: On this page you can modify result file(s) settings.  


  • No labels