Unipro UGENE User Manual
Page tree

Versions Compared

Old Version 9

changes.mady.by.user Evelina

Saved on

compared with

New Version 10

changes.mady.by.user Evelina

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

ParameterDefaultDescription
Save output to/path/to/sequence/

The folder where the "mfold" subdirectory will be created with the output data in it. By default, this folder is the same as the folder where the input sequence is stored.

For example, let's say our OS is Windows and the analyzed sequence has the path "C:\path\to\sequence\my_sequence.fa". After running the task, the folder structure will look something like this

Code Block
C:.
└───path
    └───to
        └───sequence
            │   my_sequence.fa
            │
            └───mfold
                └───2024.03.19_16-31-34
                        inp.fa_1.pdf
                        inp.fa_1.png
                        inp.fa_2.pdf
                        inp.fa_2.png
                        inp.fa_3.pdf
                        inp.fa_3.png
                        out.html
The output folder must have write permissions.


Info

Settings are not saved between dialog calls. If you need to change the output folder to something other than the default, you will have to do this manually each time.

This behavior may be corrected in future releases of UGENE.

DPI96

Setting up the Ghostscript converter from ps files to PNG. Quality of saved images (PNG files). The higher this parameter, the higher the quality, size and resolution of the resulting images.

Info

This setting only affects images in the output folder. This setting does not affect images in UGENE. This setting does not affect PDF.

Internal parameters

Settings that the user cannot explicitly influence.

  1. Molecule Type (DNA/RNA). mfold gets sequence information from command line arguments. Information about what type will be passed to the tool can be seen next to the sequence name Image Added
  2. Molecule Topology (linear/circular). mfold gets sequence information from command line arguments.
    1. If the sequence is marked as circular Image Added, then mfold will work with it as a circular one.
    2. Otherwise Image Added, as with linear one.
    3. Part of a circular sequence will also be considered a circular sequence. If you want to change this behavior, uncheck "Mark sequence as circular" and then call the mfold dialog
      Image Added
  3. DPI of images in UGENE. Ghostscript has a default DPI of 72. Therefore, this value is used for images for the internal UGENE report and this value cannot be changed.

Tool comparison

хранение результатов

...